D-Link DES-3624 - Switch - Stackable User Manual - Factory Reset
Stackable NWay Ethernet Switch User’s Guide
100
Using the Console Interface
Figure 6-63. Restart System screen
The computer will be rebooted once you press RESTART.
Factory Reset
Before performing a Factory Reset, be absolutely certain that this is what you want to do. Once the reset is done, all of
the Switch’s settings stored in NV-RAM (including TCP/IP parameters, SNMP parameters, the enabled/disabled settings
of ports, security settings, etc.) will be erased and restored to values present when the Switch was purchased.
Note:
After performing the Factory Reset, make sure to redefine the IP settings for the Switch in the Configure IP
Address
menu. Then perform a Restart System on the Switch. After these three procedures are performed,
your Factory Reset is complete.
Choose Factory Reset from the main menu. The following screen appears: