D-Link DES-3624 - Switch - Stackable User Manual - Save Changes
Stackable NWay Ethernet Switch User’s Guide
Using the Console Interface
45
Save Changes
The Switch has two levels of memory normal RAM and non-volatile or NV-RAM. Settings need to be changed in all screens
by pressing Ctrl + S. When this is done, the settings will be immediately applied to the switching software in RAM, and
will immediately take effect. Some settings, though, require you to restart the Switch before they will take effect.
Restarting the Switch will erase all settings in RAM and reload them from the NV-RAM. Thus, it is necessary to save all
settings to the NV-RAM before restarting the Switch.
In order to retain any modifications made in the current session, it is necessary to choose Save Changes from the main
menu. The following screen will appear to indicate your new settings have been processed:
Figure 6-4. Save Changes screen
After the settings have been saved to NV-RAM, they will become the default settings for the Switch, and they will be used
every time it is powered on, reset or rebooted. The only exception to this is a factory reset, which will clear all settings and
restore them to their initial values listed in Appendix D, which were present when the Switch was purchased.
Login On The Switch Console By Registered Users
To log in once you have created a registered user,
1.
Type in your username and press
2.
Type in your password and press
3.
The main menu screen will be displayed based on your Administrator or Normal User access level or privilege.
Create/Modify User Accounts
To add or change your user password: