D-Link DFE-2600 Series User Manual - Snmp Information
Dual-Speed Stackable Hubs User’s Guide
Master Hub Setup and Management
50
♦
Boot Server IP Address. This variable is the IP address of the
TFTP server where the configuration file is located. This entry is
used only if the S/W Update Control is enabled and your boot proto-
col is TFTP only; if you are using BOOTP&TFTP mode, or if Send
BOOTP Request on Power Up is enabled, the address will be ob-
tained from the BOOTP server.
♦
Boot File Name. The pathname of the configuration file on your
TFTP server. If you are using D-View as your TFTP server, this is
the pathname of the .CFG file on your hard disk. This entry is used
only if your boot protocol is TFTP ONLY; if you are using
BOOTP&TFTP mode, or if Use BOOTP to get IP after start up is
enabled, the pathname will be obtained from the BOOTP server. For
more information about the DFE-2600 series master hub configura-
tion file, see Appendix C, Boot Configuration File.
DFE-2600 Stackable Hub - Software Update Menu
Software Update
Software Update Mode
> Boot Protocol Boot Server IP Address [210.68.85.36 ] Boot File Name [c:\dfe2600i.cfg ] Last Boot Server IP Address: 210.68.85.35 HELP SAVE EXIT The System Configuration Menu screen shows a variety of information about your hub, and allows you to set the System Name, System Location,SNMP Information