D-Link DFE-2600 Series User Manual - page 90
Dual-Speed Stackable Hubs User’s Guide
Boot Configuration File
78
Takes
string
as the System Contact, corresponding to the SNMP
MIB-II object sysContact. This field is used to give the name and con-
tact information of the person responsible for the hub. The
string
can
be up to 64 characters long.
♦
syslocation
string
Takes
string
as the System Location, corresponding to the SNMP
MIB-II object sysLocation. This field is used to indicate the physical
location of the hub for administrative purposes. The
string
can be up
to 64 characters long.
♦
baud-rate
n
Sets the serial port communication rate used when the port is being used
in out-of-band mode. Legal values for the parameter
n
are: 2400, 4800,
9600, and 19200.
♦
2600h-image
string
Takes
string
(which may be up to 64 characters long) as the filename
of the image file to be downloaded from the TFTP server. When the
hub boots, it will load the given image file from the server and execute
it. This command may be used to update the hub’s software when a
new version is available from D-Link.
♦
ip-netmask
mask
Uses
mask
as the network mask for the local network. For a Class C
network with no subnetting, the netmask should be 255.255.255.0.
♦
ip-default
address