D-Link DFE-2600 Series User Manual - Resetting The Hub
Other manuals for DFE-2600 Series:
User Manual
Manual is about: DFE-2600 Series Ethernet/Fast Ethernet Dual-Speed Managed/Unmanaged Stackable Hubs
of
110
Master Hub Setup and Management
69
DFE-2600 Stackable Hub - Network Monitoring : Bridge Information
Hub ID
Bridge Present
Bridge Status
1
Bridge
Enable
2
N/A
Disable
3
N/A
Disable
5
N/A
Disable
EXIT
Resetting the Hub
You can use the console program to reset the hub stack, either doing a sys-
tem reset (which restarts the hubs and is identical to powering them off and
back on again) or a factory reset (which resets the master hub, reverts all of
its parameters back to their factory default values, and restarts the entire
hub stack).
Important Note:
If it is necessary for you to power-off
the hub (or hub stack) and then re-
start it instead of using the reset
functions, the hub MUST BE
POWERED-OFF for a MINIMUM of
TEN SECONDS.