D-Link xStack DES-3800 Series User Manual - Rip Interface Settings
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
RIP Interface Settings
RIP settings are configured for each IP interface on the Switch. Click the RIP Interface Settings link in the RIP folder. The
menu appears in table form listing settings for IP interfaces currently on the Switch. To configure RIP settings for an individual
interface, click on the hyperlinked Interface Name.
Figure 8- 13. RIP Interface Settings window
Click the hyperlinked name of the interface you want to set up for RIP, which will give access to the following menu:
Figure 8- 14. RIP Interface Settings - Edit window
Refer to the table below for a description of the available parameters for RIP interface settings.
The following RIP settings can be applied to each IP interface:
Parameter
Description
Interface Name
The name of the IP interface on which RIP is to be setup. This interface must be previously
configured on the Switch.
IP Address
The IP address corresponding to the Interface Name showing in the field above.
TX Mode
Toggle among Disabled, V1 Only, V1 Compatible, and V2 Only. This entry specifies which
version of the RIP protocol will be used to transmit RIP packets. Disabled prevents the
transmission of RIP packets.
116