D-Link xStack DES-3800 Series User Manual - Ip-Mac Binding Port
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
IP-MAC Binding Port
To enable or disable IP-MAC binding on specific ports, click IP-MAC Binding Port in the IP-MAC Binding folder on the
Administration Menu to open the IP-MAC Binding Ports Setting window. Select a port or a range of ports with the From and
To fields. Enable or disable the port with the State field. The user may also enable the ACL Mode for IP-MAC Binding which
will create two Access Profile Entries on the Switch, as previously stated. The Trap/Log field will enable and disable the sending
of trap log messages for IP-MAC binding. When enabled, the Switch will send a trap log message to the SNMP agent and the
Switch log when an ARP packet is received that doesn’t match the IP-MAC binding configuration set on the Switch. Click Apply
to save changes.
Figure 11- 4 . IP-MAC Binding Ports window
9
The following fields can be set or modified:
Parameter Description
ACL Mode
This field will enable and disable the ACL mode for IP-MAC binding on the Switch, without
altering previously set configurations. When enabled, the Switch will automatically create two
ACL packet content mask entries which will aid the user in processing certain IP-MAC binding
entries created. The ACL entries created when this command is enabled, can only be
automatically installed if the Access Profile table has two entries available of the possible 9
entries allowed.
Trap/Log
This field will enable and disable the sending of trap log messages for IP-MAC binding. When
enabled, the Switch will send a trap log message to the SNMP agent and the Switch log when
an ARP packet is received that doesn’t match the IP-MAC binding configuration set on the
Switch.
From…To
Select a port or range of ports to set for IP-MAC Binding.
State
Use the pull-down menu to enable or disable these ports for IP-MAC Binding.
238