D-Link xStack DES-3800 Series User Manual - Ip-Mac Binding Table
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
IP-MAC Binding Table
The window shown below can be used to create IP-MAC binding entries. Click the IP-MAC Binding Table in the IP-MAC
Binding folder on the Security menu to view the IP-MAC Binding Setting window. Enter the IP and MAC addresses of the
authorized users in the appropriate field, choose the designated ports, and click Add. To modify either the IP address or the MAC
address of the binding entry, make the desired changes in the appropriate field and Click Modify. To find an IP-MAC binding
entry, enter the IP and MAC addresses and click Find. To delete an entry click Delete. To clear all the entries from the table click
Delete All.
Figure 11- 5 . IP-MAC Binding Table window
0
Parameter Description
IP Address
Enter the IP address to bind to the MAC address set below.
MAC Address
Enter the MAC address to bind to the IP Address set above.
All Ports
Click this check box to configure this IP-MAC binding entry (IP Address + MAC Address) for all
ports on the Switch.
Ports
Specify the switch ports for which to configure this IP-MAC binding entry (IP Address + MAC
Address). Click the All check box to configure this entry for all ports on the Switch.
Mode
The user may set the IP-MAC Binding Mode here by using the pull-down menu. The choices
are:
ARP – Choosing this selection will set a normal IP-Mac Binding entry for the IP address and
MAC address entered.
ACL – Choosing this entry will allow only packets from the source IP-MAC binding entry
created here. All other packets with a different IP address will be discarded by the Switch. This
mode can only be used if the ACL Mode has been enabled in the IP-MAC Binding Ports
window as seen previously.
239