D-Link xStack DES-3800 Series User Manual - User Accounts
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Power Disconnect
Method
The PoE controller uses either Deny next port or Deny low priority port to offset the power
limit being exceeded and keep the Switch’s power at a usable level. Use the drop down menu
to select a Power Disconnect Method. The default for the Power Disconnect Method is Deny
next port. Both Power Disconnection Methods are described below:
Deny next port - After the power limit has been exceeded, the next port attempting to power
up is denied, regardless of its priority.
Deny low priority port - After the power limit has been exceeded, the next port attempting to
power up causes the port with the lowest priority to shut down to allow the high-priority and
critical priority ports to power up.
PoE Configuration
From… To…
Select a range of ports from the pull-down menus to be enabled or disabled for PoE.
State
Use the pull-down menu to enable or disable ports for PoE.
Priority
Use the pull-down menu to select the priority of the PoE ports.
Power Limit
Sets the power limit per PoE port. Once this threshold has been reached on the port, the PoE
will go into the Power Disconnect Method, as described above. The user may set a limit
between 1000 and 16800mW
Click Apply to implement changes made to the PoE settings. The port status of all PoE configured ports is displayed in the table
in the bottom half of the screen shown above.
User Accounts
Use the User Account Management window to control user privileges. To view existing User Accounts, open the
Administration folder and click on the User Accounts link. This will open the User Account Management window, as shown
below.
Figure 6- 7. User Accounts window
To add a new user, click on the Add button. To modify or delete an existing user, click on the Modify button for that user.
Figure 6- 8. User Accounts Add Table
Add a new user by typing in a User Name, and New Password and retype the same password in the Confirm New Password.
Choose the level of privilege (Admin, Operator or User) from the Access Right drop-down menu.
NOTICE: In case of lost passwords or password corruption, please refer to the
D-Link website and the White Paper entitled “Password Recovery Procedure”,
which will guide you through the steps necessary to resolve this issue.
40