D-Link xStack DES-3800 Series User Manual - page 200
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
To configure the Access Rule for Packet Content Mask, open the Access Profile Table and click Modify for a Packet Content
Mask entry. This will open the following screen:
Figure 10- 12. Access Rule Table (Packet Content Mask)
To remove a previously created rule, click its corresponding
button. To add a new Access Rule, click the Add button:
Figure 10- 13. Access Rule Configuration - Packet Content Mask
To set the Access Rule for the Packet Content Mask, adjust the following parameters and click Apply.
Parameter Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port
defined in the Port Mirroring window. Port Mirroring must be enabled and a target port must be
set. Remember, Port Mirroring cannot cross-box, that is they cannot span across switches in a
switch stack.
185