D-Link xStack DES-3800 Series User Manual - Dual Configuration Services
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Dual Configuration Services
The following window is used to configure firmware information set in the Switch. The xStack DES-3800 series has the capability
to store two firmware images in its memory. To view this window, open the Administration folder and click Dual
Configuration Services, which will in turn display the following window.
Figure 6- 20. Config Information window
This window holds the following information:
Parameter
Description
ID
States the ID number of the configuration file located in the Switch’s memory. The Switch can
store two configuration files for use. ID 1 will be the default boot up configuration file for the
Switch unless otherwise configured by the user.
Version
Displays the firmware version set in the Switch.
Size
Displays the size of the configuration file, in bytes.
Update time
Displays the time that the configuration file was updated to the Switch.
From
Displays the location from which the configuration file was uploaded.
User
Displays the name of the user (device) that updated this configuration file. Unknown users will be
displayed as Anonymous.
Boot Up
Click the radio button under this heading to use this configuration file as the boot up firmware for
the Switch. This will apply upon the next reboot of the Switch.
Delete
Click the corresponding
under this heading to delete this configuration file from the Switch’s
memory.
Apply
Click Apply to implement any changes made to the configuration file settings.
52