D-Link xStack DES-3800 Series User Manual - Limited Ip Multicast Range
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Limited IP Multicast Range
The Limited IP Multicast Range window allows the user to specify which multicast address(es) reports are to be received on
specified ports on the Switch. This function will therefore limit the number of reports received and the number of multicast groups
configured on the Switch. The user may set an IP address or range of IP addresses to accept reports (Permit) or deny reports
(Deny) coming into the specified switch ports. Click Security > Limited IP Multicast Range Settings to open the Limited IP
Multicast Range window shown below:
Figure 11- 5 . Limited IP Multicast Range
2
To configure Limited IP Multicast Range:
1. Choose the port or sequential range of ports using the From…To… port pull-down menus.
2. Use the remaining pull-down menus to configure the parameters described below:
Parameter Description
State
Toggle the State field to either Enabled or Disabled for a given port or group of ports where
access is to be either permitted or denied.
From Multicast IP
Enter the lowest multicast IP address of the range.
To Multicast IP
Enter the highest multicast IP address of the range.
Access
Toggle the Access field to either Permit or Deny to limit or grant access to a specified range
of Multicast addresses on a particular port or range of ports.
Delete Settings
Click the delete button to delete the settings for the Limited IP Multicast Range.
Click Apply to implement the new settings on the Switch.
241