Eaglemaster E4 User Manual - page 10
Display Beeps Vibrations Trigger
1st stage-Sensor warning
2nd stage-Sensor triggering
Trunk switch triggering
Door switch triggering
Hood switch triggering
Ignition triggering
5 short
Melody 1
Melody 2
Melody 3
Melody 4
Melody 5
1 times
1 times periodically
2
5 times periodically
times periodically
3 times periodically
4 times periodically
2-way signal paging features
A page is the signal the control module sends to the remote controls confirmation of
receipt of a command or alarm system status. When the remote control receives a page
it will generate a page notification to the user (notifications are audible beeps) and the
LCD Icons will display the current system status.
Command Page
When a command (arm/disarm, or auxiliary channel) from the remote control is sent
and received, the system will send a command page back to confirm receipt.
Alarm Page
If the alarm system is triggered while armed, an Alarm Page will be sent to the remote
control. When the remote receives an Alarm Page, the LCD icons will display the alarm
system status information and the remote control will generate beeps.
Page Recognition (Acknowledgement)
To clear a page alert/notification, quickly press any button on the remote control. This
can be performed at any time during or after the page notification has occurred.
The remote control will not send a command to the system at this time; it will only clear
future repeats of the page notification. The next time a button is pressed on the remote
control it will send a command to the system.