Eaglemaster E4 User Manual - - Remote Activates:
If the remote control has been lost or damaged, you can manually disarm your system by
programmed " Valet SW or PIN code":
Emergency disarm by Valet Switch :
(1) Turning the Ignition switch from OFF to ON position.
(2) Simply pressing and holding the Valet switch for over 3 seconds, the system will
disarmed immediately.
Emergency disarm by PIN code :
(The system's factory-set PIN code is "2 . 5" )
(1) Turning the Ignition switch from OFF to ON position.
(2) Press the Valet switch 2 times, the Valet switch pressing is according to the 1st PIN
code numbers.
(3) Turning the ignition switch OFF to ON again to insert 2nd PIN code.
(4) Press the Valet switch 5 times, the Valet switch pressing is according to the 2nd PIN
code numbers.
(5) After 2 digit PIN code has been correctly inserted, the system will disarmed immediately
and siren will give 4-short chirps.
NOTE: Each cycle of alarm triggering is only provide one time to set PIN code, otherwise
the owner must wait next cycle triggering and then set PIN code again to disarm the system.
If the owner forgot the PIN code number, must use "Emergency reset switch " to reset the
alarm system (please see "Emergency reset switch" ).
Emergency disarm (Valet SW & PIN code):
This feature will protect your vehicle in the event that there is an attempt to Hi-jack the
vehicle. The system provide 3 ways to activate the Anti car-jacking mode if programmed.
While system is trigger anti-car jack mode, lights will flash once and the LED will fast
flashing to show the system is enter anti-car jacking mode. see "anti-car jack mode table".
- Remote activates:
If programmed, to operate it when driving the car (ACC ON), press button for 2sec. The
parking lights will flash once and the LED will fast flash to show the system is entering anti
car-jack mode.
- Standby mode of door switch activates:
If programmed with the feature, to operate it when driving the car, press button for over 2sec.,
siren will give one chirp and the system now is in standby Anti car-jacking mode.
Under this standby mode, if a door is forced been open and close, the system will activate
Anti-car jack immediately. The parking lights will flash once to show the system is enter
anti car-jack mode.
EXIT: Under standby mode, you may exit this mode, if it is not activate the door, press
button for over 2 seconds, siren will give two chirps and LED off.