Eaglemaster E4 User Manual - - 2 Step Disarm:

- Arming without Remote control:  

This function gives you a possibility to Arm and Disarm the system use original key and Valet 

switch,  After driving and ignition keep ON , open the door, then turn off the ignition Key and 

press the Valet switch once, then closed  the door, the system will armed immediately.

Note: if programmed with Passive arm feature, this feature will not activated. 

Note: if you failure to  lock the door with original key within 15sec., then you may repeat 

          it's procedure again  

         (This specify procedure to avoid any false arm the system through indoor switch or 

           other situation etc.,..)     

- 2 step disarm: 

This system offers 2 step disarm. It's a feature that make it possible to silence and reset 

the system while it is triggering, without disarming the system. If the system is triggered 

and the siren has been sounding, pressing any button once on the remote transmitter will 

stop the trigger and return the unit to the armed state.

Note: If press 2-way remote control button once, will stop the beep sound and LCD display 

will indicate the intrusion icon for 2sec. Press any button again to stop alarm triggering.   

- Remote trunk open:

Simply press and hold button       over 2 seconds, the channel will output for 1 second pulse , 

this feature normally for open the trunk.  

Note: 

If trunk has been remote opened in arming position, trunk switch will delay sensing for 

           30 seconds, and the shock sensor will be bypassed. 

2-way LCD display : 

In Armed position, if remote trunk open, the 2-way

LCD will display trunk icon and give one beep .

If trunk closed, trunk icon off and give one beep. 

If still keep opened, after 1Min. The 2-way remote will

give pre-warn beep sound.