Eaglemaster E4 User Manual - - to Disarm The System :
- To DISARM the system :
To disarm your system within proper operating range, simply press button once (while
system in arm position). The system will respond two siren chirp, two light flash, doors unlock,
Enable your engine starter, LED off.
- Intrusion Alert:
Upon disarming the system, if the vehicle is attempted or intruded, siren and lights will Indicates
4 chirps and 5 flashes to identify which zone was triggered. LED mode indicates the following
different triggering.
flash 2 times after a pause Sensor 1st-stage triggered
flash 3 times after a pause Sensor 2nd-stage triggered
flash 4 times after a pause Door switch triggered
flash 5 times after a pause Trunk switch triggered
flash 6 times after a pause Hood switch triggered
Flash 7times after a pause Ignition switch triggered
- 2-way LCD Intrusion Alert:
Upon disarming the system, if the vehicle is attempted or intruded, the 2-way remote will respond
2 short beep follow with melody sound, and LCD display will indicates different icons as under:
1st-stage sensor
triggered
2nd-stage sensor
triggered
Door switch triggered
Trunk switch triggered
Hood switch triggered
Ignition switch triggered
Note: Before the ignition turn on, you may realized again which zone been triggered by press
button (status check) once, the LCD will display triggered zone again.
-14-
2-way LCD display :
+ Two beep sound