Eaglemaster E4 User Manual - R.F Antenna Call Switch :

Call switch 

R.F Antenna CALL SWITCH :

Set your own PIN code :

The R.F antenna module provide a switch which can be 

send a signal to the 2-way remote. 

In disarmed or ACC on position, if press Call switch for 

2 seconds, lights will flashing 5 times and the 2-way 

remote will give pre-warn beep sound . The vehicle 

page mode icon displays when the alarm module is 

paging the transceiver.

The system provide 2 digit PIN code and it can be programme your own PIN code.

Whenever you set your own PIN code of the system, the procedures are as following:

1.

 Enter Valet mode, the LED on status. 

2.

 Turning ignition switch ON to OFF for 8 times within 10sec. , and steady in OFF 

     position, siren will provide 1 long chirp.

     (Each time ignition switch turned off, siren will give 2 chirps for indication)

3.

 Now you have insert your former (old)PIN code to release this programming 

     mode. For example your old PIN code is "2.5", turn ignition ON , LED start 

     flashing (the times of LED flashing is according to the 1st PIN code), While LED 

     flashing 2 times then turn ignition OFF, thus the 1st PIN code entered. 

     Turn ignition ON again, LED start flashing, while it flashing 5 times then turn 

     ignition OFF, thus the 2nd PIN code entered.

     If the 2-digits PIN code entered correctly, the siren will provide 2 long chirp and 

     LED off . System now is in the new PIN code programming mode.  

     Note: If enter not correct PIN code, siren will give 2 short chirps and exit this 

                mode and back to Valet mode. Please repeat procedure step # 4 again. 

4.

 Follow from 2-long chirp, the system under new PIN code setting mode.

     Suppose to set new PIN code : ( 3 . 8)., Turn ignition to ON , at time the LED will

     start flashing (the times of LED flashing is according to the 1st PIN code), While 

     LED flashing 3 times then turn ignition OFF, thus the 1st PIN code been 

     programmed. 

     Turn ignition to ON again, LED start flashing, while it flashing 8 times then turn 

     ignition OFF, thus the 2nd PIN code been programmed. 

5.

 At the time system of Led will indicating to identify the New Pin code.3.8 (3 flash 

     Pulse then 8 flash). Siren will give 2 short chirps to identify the new PIN has been 

     programmed.

6.

  Then system existed new pin code setting and return back to the Valet mode. 

+ pre-warn sound

2-way LCD display :