Eaglemaster E4 User Manual - To Arm The System:
-
To ARM the system:
To arm your system within proper operation range, simply press button once (while system
in disarmed or Acc off position) . The system will respond one siren chirp, one lights flash,
doors lock, disable engine starter, LED will begin flashing quickly until all sensor inputs are active
- LED will start blinking slowly (flash once per second) to indicate the system is in full armed.
-
Defective Zone Bypass & Alert:
-
Auto Reset:
If a violation occurs the system will respond by sounding the siren and flashing the lights for
approximately 30sec. before the system resets itself and continues to protect your car. If violation
still occurs the system, siren and lights will working for 8 cycles then the system reset itself and
continues to protect other zones.
- Arm without siren chirp :
You may temporarily to arm your system without siren chirp , to operate it by simply press button
once then within 3sec. press button once.
The system will armed and without one siren chirp,
Note: this features is only activated under the system is in disarmed and Acc off position,.
If the security system is armed at the same time that an input is active (such as a door opening
or hood / trunk opening ), you will hear one siren chirp to indicate arming and after 8 seconds
a second siren chirp to indicate Bypass Notification. A Bypass Notification chirp means that the
security system ignores the input that was active when the system was armed, until that input
ceases.
Defective zone Siren chirps 2-way beeps 2-way LCD indicator
2-way LCD display :
+ One beep sound
Note: You may press 2-way remote button once to check again which zone is not closed.
Door opened 3 chirps 1 long + 3 short
Trunk opened 4 chirps 1 long + 4 short
Hood opened 5 chirps 1 long + 5 short
-13-