Eaglemaster E4 User Manual - - Status Led Timer:

- Siren chirps ON/OFF (programmable):   

This programme feature controls the chirps that confirm the arming , disarming and  intrusion 

alert of the system.

Note: Set siren chirp off, if door, hood or trunk not closed, siren will activated. 

- Power disconnecting memory :

Alarm is built in memory on main unit. Generally, after alarm power is cut off and reconnect,

main unit will read back these data make the alarm to resume.

- Red/black wire positive (+) programme input : 

This wire Red/black is a (+) positive input  can be controlled functions as : reverse

warning / Door lock / AV sw for 2nd step disarm .

Reverse waring: 

If programmed with the feature, when you are reversing your car the parking lights will 

flashing and siren will chirping (if programmed with siren) to prevent accident impacts to 

animal or human body.

Note: you can proceed the Reverse warning without siren chirps :  (1) when you activated 

            the Disarm w/o chirp before Ignition On.  (2)  when you reversing the Car simply press 

            the button        once.  

Door lock : 

If programmed with the feature, doors will lock when activate this wire.  

AV sw for 2nd step disarm: 

If programmed with the feature,  when disarming the system by the remote, however the 

engine will still blocked, turn on the ignition the 2way will indicate flash icon                and give

 beep sound to indicate that the engine is blocked. 

Exit: Turn ignition ON then press this AV switch once  to release the start killer. This AV sw 

          can be installed any O/E switch as long as it (+) positive input.                

- Status LED timer: 

If the alarm system armed after 24 hours, the LED will blink shortly once per second.

Armed after 25~48 hours, the LED will blink shortly once every 3 seconds.

Armed after 48 hours, the LED will blink shortly once every 5 seconds. 

-Horn pulse:  

If programmed with Horn pulse output, for additional vehicle's horn honk output alert.  

- Emergency reset switch: (for installer only) 

If the remote has been lost or damage, or forgot the PIN code number  the owner can 

enter the car by using the key.  It will act the alarm. To disarm the alarm turn ignition on 

and connect  "reset switch" for over 2sec. , it will disarm the alarm immediately. (Please 

ask your installer this reset switch location). 

Note: after this emergency reset activated, the PIN code will resumed factory setting 

           PIN code " 2 . 5 "