EarthWalk eBuddy Series 3 User Manual - Internal Modem
Chapter 2: Peripherals and accessories
eBuddy User Manual
-30-
2/4/00
Internal modem
The eBuddy comes equipped with an internal 56.6 Kbps software modem. In
order for the modem to function properly, you should select UART2 mode as
modem in the Integrated Peripherals setup in BIOS setup (see “Integrated
peripherals” on page 77).
The telephone cord connects to the jack on the right side of the eBuddy as
shown in Figure 2-9.
Installing the modem telephone cord
To install the modem telephone cord (refer to Figure 2-10):
1. Turn the eBuddy’s power off.
2. Open the cover of the modem phone jack on the right side of the eBuddy as
shown in (1).
3. Insert the modular plug of the telephone cord at about 45° into the phone
jack until it clicks firmly into place, as shown in (2).
Removing a modem telephone cord
To remove the modem telephone cord (refer to Figure 2-11):
1. Turn the eBuddy’s power off.
2. Press the telephone cord security lock as shown in (1).
3. Slowly and gently remove the modular plug from the jack as shown in (2).
4. Close the modem phone jack cover.
Figure 2-9. Modem phone jack
ebud.book Page 30 Friday, February 4, 2000 11:11 AM