EarthWalk eBuddy Series 3 User Manual - page 84
Manual is about: Student Laptop
of
99
PNP/PCI configuration
2/4/00
-75-
eBuddy User Manual
If you have a PCI controller, change this setting to specify which slot has the
controller and which PCI interrupt (A, B, C, or D) is associated with the con-
nected hard drives.
Remember that this setting refers to the hard disk drive itself, rather than indi-
vidual partitions. Since each IDE controller supports two separate hard drives,
you can select the INT# for each. You will note that the primary has a lower
interrupt than the secondary as described in lot x using INT# above.
Selecting PCI Auto allows the system to automatically determine how your
IDE disk system is configured.
ebud.book Page 75 Friday, February 4, 2000 11:11 AM