EarthWalk eBuddy Series 3 User Manual - page 55
Manual is about: Student Laptop
of
99
Chapter 3: Hardware installation
eBuddy User Manual
-46-
2/4/00
3. Close the display panel and remove any cables connected to the eBuddy.
4. Place the eBuddy upside-down on a flat surface.
5. Remove the two screws from the memory panel cover, as shown in (1) in
Figure 3-1.
6. Remove the memory cover, as shown in (2) in Figure 3-1.
7. Release the latches on each side of the memory module, as shown in (1) in
Figure 3-2.
8. Lift the memory module until it is approximately 45° from the eBuddy, as
shown in (2) in Figure 3-2.
9. Remove the memory module, as shown in (3) in Figure 3-2.
Figure 3-2. Removing memory
ebud.book Page 46 Friday, February 4, 2000 11:11 AM