EDAN H100B User Manual - Waveform Mode
of
99
H100B Pulse Oximeter User Manual
- 32 -
Figure 3-2 Model
If the POST is successfully finished, the
oximeter sounds a tone and enters the main
interface.
If there is an error during the POST, the following error
codes will display on the screen:
Error code
Indication
Error 01
Indicates error for low battery
Error 02
Indicates error for SpO
2
board
Error 03
Indicates error for main control board
3.2 Measurement State
3.2.1 Measurement Modes
There are two measurement modes which are waveform
mode and large numeric mode. By default, the
configuration is waveform mode.
Waveform Mode
In the normal measurement state, oximeter can measure