F-SECURE ANTI-VIRUS FOR MICROSOFT EXCHANGE 6.62 - Administrator's Manual - page 75
CHAPTER 4
75
Using F-Secure Anti-Virus for Microsoft Exchange
4.7
Modifying Settings and Viewing Statistics
This section describes how you can modify product settings and view
product statistics in both centrally administered and stand-alone mode.
4.7.1
Centrally Administered Mode
To change F-Secure Anti-Virus for Microsoft Exchange settings in the
centrally administered mode, select F-Secure Anti-Virus for Microsoft
Exchange from the Properties pane. Make sure the Policy tab is selected
and assign values to variables under the Settings branch. Modify settings
by assigning new values to the basic leaf node variables (marked by the
leaf icons) shown in the Policy tab of the Properties pane. Initially, every
variable has a default value, which is displayed in gray. Select the
variable from the Properties pane and enter the new value in the Editor
pane to change it. You can either type the new value or select it from a list
box. If you enter an invalid value, it will be displayed in red in the
Properties pane. Click
Clear
to revert to the default value or
Undo
to
cancel the most recent change that has not been distributed. For detailed
explanations of all variables, see “
F-Secure Anti-Virus for Microsoft
Select the Status tab of the Properties pane to view statistics and the
settings that were configured during the installation of F-Secure Content
Scanner Server and F-Secure Anti-Virus for Microsoft Exchange.
Statistics are updated periodically and can be reset by choosing Reset
Statistics on the Policy tab of the Properties pane. For more information,
F-Secure Anti-Virus for Microsoft Exchange Statistics
Settings that are configured during the installation and the initial
setup require that you select the Final check box from the Product
View pane. These settings include Primary and Backup Content
Scanner Servers and Quarantine settings.