Faroudja Native Rate Series Installation And Operation Manual - page 12
Picture OSD
Use these commands to fine tune the image
Display OSD
Use these commands to adjust the image position
and edge blanking. It is recommended to adjust
sizing and blanking in the display device first. This
should be done by a qualified technician.
Patterns OSD
These patterns are used to setup and align the
image. This should be done by a qualified
technician only.
Available Patterns:
PLUGE:
Set Brightness and Contrast
100IRE Window:
Check displays power supply
Active Borders:
Use for H&V positioning
10-step Gray Scale:
Check gray scale
Convergence:
Check convergence of display
100IRE Rev.
CB: color bars for decoder check
100IRE CB:
Color bars for decoder check
Blue Screen:
Check for defective pixels
Red Screen:
Check for defective pixels
Green Screen:
Check for defective pixels
Cr Ramp:
Check linearity of Cr channel
Cb Ramp:
Check linearity of Cb channel
Luma Ramp:
Check linearity of Luma channel
Use these patterns to adjust the image and
processor. Use the Function key on the remote to
the Select bar after activating the test patterns.
Use the Value key to select the test patterns.
Select the Picture menu to adjust the image. Store
the new settings in a preset. Then be sure to return
to the patterns menu to turn off the test patterns.
10
IR REMOTE AND OSD OPERATION