Faroudja Native Rate Series Installation And Operation Manual - page 44
INFRARED TEACHING COMMANDS
To control all the functions in the NRS-DCS
processor commands from both remotes will
need to be learned.
• For the larger remote with operations for
the DVD transport, simply point the remote at
the learning remote to store all the available
operations (See list of commands below).
• For the smaller remote and to control the
operations for the NRS-DCS processor the
discrete commands are taught by flashing
the commands from the front of the NRS-DCS
processor. The flasheris located behind the
IR receiver lens located on the left side of
the front panel.
• To learn the NRS-DCS codes, position the
learning remote in front of the IR receiver lens.
• Press the Setup key on the front panel.
• Use the Up/Down keys to locate IR Setup
Menu, press Enter.
• Use the Value key to select the different
commands. Each time the Enter button is
pressed it flashes” the commands out through
the IR receiver window on the front panel.
• Number of Samples: defines how many
times the NRS-DCS will send the sample IR
command. Adjust this if learning remote
does not respond properly.
Power On/Off
(toggle)
Input
Aspect Ratio
Brightness
Contrast
Color
Tint
Detail
Noise Reduction
Function Up /
(Up Direction)
Function Down /
(Down Direction)
Value up /
(Right Direction)
Value Down /
(Left Direction)
Preset / Enter
42
0
1
2
3
4
5
6
7
8
9
DVD (input)
Video (input)
S-video (input)
YCrCb (input)
RGB (input)
4:3
(aspect ratio)
Letterbox
(aspect ratio)
Anamorphic
(aspect ratio)
Power On
Power Off
Preset 1
Preset 2
Preset 3
Preset 4
Factory
Return NRS-DCS
DVD Factory
DVD Animation
Use the large DVD remote to learn the
DVD transport commands
IR TEACHING COMMAND LIST
(From NRS-DCS front panel)