Faroudja Native Rate Series Installation And Operation Manual - page 8
SYSTEM FIRMWARE SETUP
SYSTEM FIRMWARE SETUP
Now that all the sources and cables are
connected, the processor’s firmware needs to be
fine-tuned for the installation. The System Setup
menu is only accessible from the front panel.
RS232 commands can also be used.
Be sure to go through the Setup menu before
doing the final setup of the display.
To enter the System menu, press the Setup
button and then Enter
There are four sections to the System Setting.
Pressing the Enter key to open that set of
Functions:
• System Menu
• User Mode
• I/R Setup
• Test Patterns
Pressing the Up button will recall the available
Functions. Press the Left or Right keys to select or
change values. When no commands are entered
after a short period the front panel LCD will switch
to the main window. Just hit the Up or Down but-
tons to jump back to the control menu last used.
SYSTEM MENU FUNCTIONS
Screen Shape
4:3 / WideScreen / Wide 4:3
4:3 – Choose this when the projector is 4:3
and the screen is 4:3
Example:: using a 1024x768 digital projector on a
4:3 screen.
WideScreen-Choose this when the screen is
Widescreen and the projector will provide the
anamorphic vertical squeeze.
Example: A 16:9 plasma, a digital or CRT
projector set to Anamorphic using a wide angle
screen or when using a Panamorph lens.
Wide 4:3-choose this when the projector is
4:3 only and the screen is Widescreen.
(Not available on units scanning at rates
below 720p)
Example: A digital projector that is 4:3 only with a
wide angle screen.
Initial Storing of the main Screen Shape.
The NRS-DCS allows for storing different screen
shapes in the Custom Presets such as with instal-
lations where two different display types are used.
Step one is to set the main screen shape:
• Select an Input (not Pass-Through)
• Enter the System Setup Menu
• Select desired Screen Shape
• Use the Function keys to select
Save to All and press Enter
The screen shape is now stored for all
Inputs and Presets.
Storing a second screen shape in
the Custom Presets
A secondary screen shape or position setting or
blanking setting can be saved as a Custom Preset:
• Enter the System Menu and choose the new
settings
Note: Do NOT use the Save to All command)
• Press Return
• Press Enter, then press Preset 1-4
Output Select - Analog/Digital
This must be selected to determine if the Analog
((BNC/D15) or Digital (DVI) outputs are used.
Both outputs cannot be used at the same time.
When DVI is selected the following controls are not
available:
Output Format, Sync on Green and Sync on H.
Save to All – Press Enter
Saves System setup (screen shape, blanking,
image position) to all presets.
Be sure to do this when initial installation is
completed.
I/R Receiver – On/Off
Controls front panel IR receiver
RS232 Echo:
On(Default)/Off
Select if the RS232 commands returns a status
report to the control system.
DCDi Mode:
On (Default)/ Off
Should always be On
Film Mode:
On (Default)/Off
6