Faroudja Native Rate Series Installation And Operation Manual - page 41
RS232 INSTRUCTION
COMMAND
AD
A#
AN
B#
C#
CL
CM
D#
DC#
DIG#
DSP
DVD
ENT
EXT
FD
FM#
FOR
FST
FU
HELP
K#
L#
LM
MENU
N#
NXT
OFF
ON
OP
P#
CONTROL COMMANDS
OPTIONS OR RANGE
(0-2) 0=4x3,1=Letterbox,
2=Anamorphic
(0-170) 128 default
(0-155) 110 default
(0-13) 8 default
1=On 0=OFF
(0-9)
1=On 0=OFF
(0-220) 128 default
(1-4)
(0-18) 8 default
(0-4) [1-4=User, 0=Factory]
(Used for day-to-day operation)
DESCRIPTION
Audio – select audio type from DVD drive
Input Aspect Ratio – for all sources
Angle – multi-camera angle for DVD drive
Brightness
Contrast
Close/Open - for DVD transport
Condition Memory – for DVD transport
Detail
DCDi Mode – this should stay ON
Digits 0-9
Display – for DVD transport
DVD – input select
Enter – functions for processor and DVD transport
Pass-through Input
Function Down
Film Mode – This should always be On
Forward
Report Current System Status
Function Up
Display this Help Menu
Color
Store User Preset
Last Memory – for DVD transport
Menu – recalls DVD menu when input is selected
Noise Reduction
Next – chapter skip forward for DVD transport
Power OFF
Power ON
Open/Close – DVD transport door
Recall Preset
RS232 INSTRUCTIONS
Connector: DB-9 Female
Baud rate: 9600 default, 8 bit,
1 stop bit and No Parity
Pin Configuration:
Pin 5 = Ground
Pin 3 = Rx
Pin 2 = Tx
All commands are sent using ASCII text strings.
Note: A command must start with the string
header "NRS"
Following the header, a comma is used to delimit
the header from the command. All the commands
with their descriptions are listed below. All the text
strings are terminated with a carriage return (0x13).
Maximum command string length is 50 characters.
The header and command are not case sensitive.
39