Faroudja Native Rate Series Installation And Operation Manual - page 7
FRONT PANEL CONTROL
FRONT PANEL CONTROL
1. Infrared Receiver / Flasher window
2. Firmware Reset:
push a small paper clip into
this opening to reset the unit’s CPU.
3. Power/Standby: Press to turn the unit On
(LED turns Green) or to Standby (Red)
4. Input Selection
5. Aspect Ratio Selection: If an aspect ratio is not
available (LED is not activated), it cannot be
selected.
Note: The screen shape used in the installation
must be set in the Setup Menu during
installation for proper Aspect Ratio mapping.
Anamorphic Aspect Ratio with 4:3 screens and
the Wide-4:3 settings are not available on units
with scan rates 480p, 540p, 600p and Frame
Doubling. See Setup section for details.
Note: Do not leave a 4:3 image with a Wide Angle
screen on for long periods of time on a CRT
projector or plasma display. This can cause
permanent image burn-in. Image burn-in is
not covered by Faroudja’s warranty.
6. Menu: Accesses DVD Menu when the internal
DVD drive is selected and a DVD disc is playing.
Menu does not function with other inputs or
when there is not a DVD disc in the player.
7. Setup: Accesses the various Setup menus in
the processor: System Setup, DVD Setup, IR
Setup and Test Patterns. See each section in
this manual for details.
8. Return: Pressing this button from any location
in any menu returns the front panel controls to
the User menu.
9. Custom Presets: There are a total of four cus-
tom presets that store all image and setup para-
meters and includes the Input. In addition, when
changing inputs, the last used setting for each
input will be recalled even if the settings were
not stored in a Preset.
10. Factory Preset: Recalls all settings to Factory
levels. Pressing once while adjusting a setting
will recall that setting back to the factory
default. Pressing the Factory button twice
returns all image settings to the factory default.
STORING PRESETS
• Adjust the image and other parameters as
needed.
• Press the Enter button, the Preset LEDs turn
Red. (Press Enter again to cancel procedure)
• Press the Preset you want to use and the LED
on that Preset will turn green, storing the pre-
set.
11. Directional buttons and Enter: These buttons
have multiple uses. While viewing any input,
pressing the Up/Down buttons will select the
User Menu Functions ( Contrast, Brightness,
etc), pressing the Left/Right buttons will
change the Values of the Functions. When in
the different Setup menus (System Setup,
DVD, etc) the directional buttons will navigate
within those menu choices. Press the Enter
when prompted by the menu to select the
Function listed.
12. DVD Transport buttons: These will control the
internal DVD drive. Pressing the Play button
will switch the input of the processor to the
DVD input. See the DVD portion of the manual
for details.
5