Faroudja Native Rate Series Installation And Operation Manual - page 5
3
INSTALLATION
UNPACKING
Remove the NRS-DCS unit from the shipping
container and examine it for any signs of shipping
damage or missing items (check inventory list
below). All shipping materials should be saved if
the unit is to be moved or returned for service.
INSTALLATION
The processor can be either placed on a table or
rack mounted. If the rack mounting installation kit
is used, the rack mount ears are mounted by
using 3 screws. It will be necessary to support
the rear of the unit if it will be shipped in the rack
by using rack support rails supplied by the rack
manufacturer.
VENTILLATION
The unit uses convection to cool. A fan is not
needed. As hot air raises out of the top vent, cool
air is drawn in from the bottom. These vents must
not be blocked. When rack mounted, a minimum
of 1.75" (1 rack unit height) of free space is
required above and below the unit to allow for
proper cooling. A forced air fan should be added
to the rack installation if power amps are located in
the same air space.
Inventory
1-NRS-DCS Unit
2-Remote + Batteries
1-Remote Order Form 1-Warrantee Card
1-Power Cord
1-Owner's Manual
REAR PANEL I/O
1. S-Video (4 Pin DIN) Input
2. Composite Video (BNC) Input
3. Interlaced or Progressive Component or RGBs
Video Input (BNC)
Note: do not use the progressive output
from DVD players
4. High Resolution HDTV/Computer Pass-
Through Input - RGBHV or YPrPb (D15M)
5. RGBH/CV or YPrPb Output(D15F)
6. RGBH/CV or YPrPb Output (BNC)
Note: Both analog video outputs can be
used simultaneously
7. Screen Trigger 12V, 3.5mm, 2 pin,Tip=+)
8. Remote IR sensor (5V-12V, 3.5mm, Tip=+)
9. RS232 Port (D9F)
10. AC Power
11. Digital Audio Outputs (Digital Audio from
internal DVD drive only) AES/EBU, Coaxial and
BNC, RCA.
12. Digital Video Interface Input and Output.