Gardsman CTC-1131 Installation, Programming, Operating - 3.13. Remote Access
32
AC Power Fail
After AC power is failed for 15 sec, the
yellow LED will light and the fault
message will be displayed. After I hour,
if the AC power is not restored, the
CTC-1132 will dial out and play the
Address message.
Panel Sabotaged
If the Tamper switch on the Control
Panel is triggered while the system
is in Armed & Home mode, the
Control Panel will sound an audible
alarm and report Burglary alarm.
While if the system is in Alarm off
mode, no alarm will be generated.
Sensor Sabotaged
If the Tamper switch on the PIR
Sensor or Door Contact is triggered
while the system is in Arm & Home
mode, the Control Panel will sound
an audible alarm and report
Burglary alarm .
While if the system is in Alarm off
mode, no alarm will be generated.
Sensor out-of-order
When the system is in Arm mode
and the Control Panel can’t receive
the supervisory signal from each
individual PIR sensor, Door Contact
or Smoke Sensor for a supervisory
period, that is set on Page 14 / 24.
Supervision, the Control Panel will
sound an audible alarm and yellow
LED will light while this fault
message can be viewed on LCD
under Fault Display.
While the system is in Disarmed
mode, no alarm event will be
generated.
3.12.5. Fault Message Nomenclature
The fault event message is displayed in
short form as below:
Fault Condition
― Message displayed
AC Power Fail
― AC failure
Control Panel
sabotaged
― Panel Tamper
Sensor Sabotaged
― (Sensor w/ Zone
Name) + Tamper
Sensor out-of-order
― (Sensor w/ Zone
Name) + out
<
<
N
N
O
O
T
T
E
E
>
>
While you arm the system, if any of Door
Contact or PIR is triggered,, arming is
also prohibited and the sensor triggered
will be displayed as fault message.
Sensor triggered
Message displayed
Door Contact
triggered
(DC w/ Zone Name) +
open
PIR triggered
(IR w/ Zone Name) +
Active
3.13. Remote Access
Via Regular
Phone Lines
The Unit can be controlled by Remote Control
Commands sent via Regular phone call.
DTMF Remote Control Command Table