Gardsman CTC-1131 Installation, Programming, Operating - 1.2. The Power Supply
2
1.2. The Power Supply
An AC power adapter is required to connect to
a wall outlet. Be sure only to use an adapter
with the appropriate AC voltage rating to
prevent component damage. A DC 9V output
and 500mA adapter is generally used to power
the Control Panel.
Rechargeable Battery
In addition to the adapter, there is a
rechargeable
battery
inside
the
Control Panel that serves as a back
up in case of a power failure.
The battery used is a 7.2V 600 mAH
Ni-mH rechargeable battery pack.
During normal operation, the AC
power adapter is used to supply
power to the Control Panel and at the
same time recharge the battery.
When the battery is fully charged, it
can provide back-up power for a
period of at least 8 hours. It takes
approximately 48 hours to fully charge
the battery.
1.3. Connecting the telephone
line
One telephone jacks can be found next to the
DC jack for the connection of your telephone
line.
Plug one end of the enclosed
telephone cable into the socket jack
on the wall.
Plug the other end of the enclosed
telephone cable into the socket
marked Line .
1.4. How to install the Control
Panel
The easiest way to get to know the system
and get it up and running quickly is to get
all
the
devices
and
accessories
programmed on a tabletop before locating
and mounting them.
The Control Panel can be mounted on the wall
or wherever desired. Ensure the Control Panel
is fitted at approximately chest height where
the display can be easily seen and the keypad
convenient to operate.
Using the 2 holes of the Wall Mounting
Cross Bracket as a template, mark off the
holes’ positions.
Drill 2 holes and fix the screws & plugs
provided.
Hook the CTC-1131 unit onto the Wall
Mounting Cross Bracket (holding the unit
with the front facing you).
1.5. Two-Level Passwords
In order to provide highest security in operating
the system, CTC-1131 offers 2 levels of
authorization. When you want to program the
system, you have to enter Personal PIN Code
and Master Code.
PIN Code
There are a total of 4 User PIN Codes
per system. The PIN Code is the 1st
level of password. When the display
panel asks you to key in Enter Code or
P-Code, please enter your User PIN
Code.
1234 is set as default User 1 PIN Code
by the factory.
User 2~4 PIN codes are deactivated by
factory default.
Master Code
The Master Code has the authorization to
enter Programming mode. When the
display panel asks you to key in M-Code,
please enter your Master Code.
1111 is set as default Master Code by the
factory.
<
<
N
N
O
O
T
T
E
E
>
>
Any of the Codes can NOT be set the
same. If you set the same number, the
display panel will show: Code is use,
select another to prompt the user to
choose differently.
1.6. Getting Started
Step 1. Find a suitable location for the Control
Panel to be installed.
Step 2. Apply the AC Power. You will hear a
long beep. Alarm On will be
displayed on the first line and 00:01
01 Jan displayed on the second line