Gardsman CTC-1131 Installation, Programming, Operating - page 8
6
Step 4. Press OK, then the previous stored
number will be deleted.
Special Characters for Setting
Two special keys
* & # are provided to help
you to store the number:
* represents a 3 seconds delay or
pause and the Control Panel will not
dial
*.
# key, which the Control Panel will dial
as it is entered.
Storing a pager number
Pager number
– * - # – Identity
code
– # - OK
The Identity code is a number that
you can key in at your discretion.
This enables the recipient to know the
call is from the Auto Dialer.
You can choose to use any number of
* or # to match the protocols of the
pager system used in your area.
Storing a Telephone Number in
EPABX phone system
EPABX Access code 0/9/8
–*– Tel.
Number
– OK
You can add as many
* as required.
Storing a Telephone Number with
extension number
Tel number
– * – * – extension
number
– OK
You can add as many
* as required.
2.2.2.Record A ddress Message
Recording Address message
Step 1. Move the cursor to select Rec.
Address and then press OK, the
screen will ask you to confirm.
C h a n g e
S t a r t R e c o r d i n g
Step 2. Press
to abort. Or press OK to
confirm, a prompt Message will be
displayed for 2 sec.
S t a r t R e c o r d i n g
A f t e r t h e B e e p
Step 3. After 2 sec, the Control Panel will
sound a long beep, the following
prompt message will be displayed,
and recording can be started.
* N o w R e c o r d i n g *
E n d w i t h O k
Step 4. Press OK to end the message.
<
<
N
N
O
O
T
T
E
E
>
>
Any time, press will abort recording
and the message will not be saved.
The maximum length of Address
message is 10 sec. When the 10 sec
duration is over, recording will be
stopped automatically. The message
being recorded will be saved.
When recording, make sure you are
facing the microphone and are within
30 cm of it.
Address message must be recorded
before the Control Panel will dial out
at an Alarm situation
Messages
Address message has a capacity of
10 seconds. Other messages are
preset in the control unit.
In an emergency, the Control Panel
will
dial
the
emergency
phone
numbers according to the priority
order. It will first play the Address
message then play the specific
message (Emergency, Fire, Burglar,
and
ACK).
Then
play
Acknowledgement message.
2.2.3. Test Report
Control unit allows you to test whether
telephone function is working properly or not
with the pre-set telephone numbers.
Step 1. Use V or
Λ cursors to select the test-
call number to test dial. Press OK to
confirm.
Step 2. Following screen will appear:
D i a l i n g . . . . . . . . .