Gardsman CTC-1131 Installation, Programming, Operating - page 36
34
period of 85 seconds; the Control Panel
will then consider the call as unsuccessful
and will try to dial the next phone number
in priority.
If more than one number is programmed
the Control Panel will continue to dial the
number(s) until two emergency calls are
successfully answered with either 0, 1 or
closed
down
with
a
key
9
acknowledgement.
<
<
N
N
O
O
T
T
E
E
>
>
CTC-1131 Auto-Dialling features only
operate under Tone-Dialling method.
3.14.2. Call A cknowledgment
If the recipient successfully receives the
call, he should acknowledge it by pressing
the 9 button on his telephone set.
Acknowledging with signal 0
If the recipient presses 0 on his phone
set as the acknowledging signal. The
Control Panel will then take the following
actions.
The Control Panel will go back on-
hook.
The Control Panel will continue
Alarming.
The Control Panel will try to dial the
phone numbers of the next priorities
until
two
recipients
have
acknowledged the call.
Acknowledging with signal 1
The recipient can press 1to
acknowledge the call and also initiate a
One-way Listen-In Channel. This
channel allows the recipient to listen in
to what is happening to the other side of
the line.
Press 1 to open a One-way Listen-In
Channel for 2 mins.
During the Listen-In period the CTC-
1131
will
sound
audible
beep
signaling 20 secs time remaining
alerts to the recipient.
If the 2-minute listen-in period is up,
the CTC-1131 will automatically hang
up the line.
Each Press 1 will extend for an
additional 2 mins.
Acknowledging with signal 9
If the recipient presses 9 on his phone
set as the acknowledging signal, the
following will happen:
The Control Panel will go back on-
hook.
The Control Panel will stop alarming
and stop dialing.
3.14.3. A uto Redial
When only one Emergency phone number
is stored and that number is engaged, the
Control Panel will automatically redial that
number up to maximum of 5 times with an
interval of 62 sec. between dialing
attempts.
When more than one telephone numbers
are stored, the Control Panel will dial in
accordance to the set priority order. If the
number being dialed is engaged, it will try
the next number. Each number will be
tried a maximum of 5 times and the redial
interval between each number is 5 sec.
The maximum number of times the Control
Panel will retry is 15 times.
<
<
N
N
O
O
T
T
E
E
>
>
If no phone Number is programmed,
the Control Panel will not dial.
When dialing a pager number, the