Gardsman CTC-1131 Installation, Programming, Operating - 2.2. Telephone Settings
4
2. Configuring Your System
2.1. Entering Programming Mode
If the system is in Disarmed (Alarm off) mode,
to enter the Programming mode, follow the
steps below.
Step 1. Press # key.
The screen will prompt you to enter
the User1 PIN code.
P - M o d e E n t e r
P - C o d e . . . .
Step 2. Key in 1234 (default User1 PIN code)
within 30 sec. Then, press OK
The screen will prompt you to enter
the Master PIN code.
P - M o d e E n t e r
M - C o d e . . . .
<
<
N
N
O
O
T
T
E
E
>
>
During keying in the PIN code, press
will clear the code field (making all
the dots again). If the code field is
empty, press
, the screen will exit
and return to Alarm Off screen.
Step 3. Key in 1111 (default Master Code)
within 30 sec.
Step 4. Press OK
The following message is displayed
for 2 sec.
P r o g r a m M e n u
M a k e a S e l e c t i o n
Step 5. Then the Programming Main menu
will be displayed.
W a l k T e s t
T e l . S e t t i n g s
<
<
N
N
O
O
T
T
E
E
>
>
The cursor is indicated by a flashing
dot on the left upper corner. It can be
move up & down by pressing &
key respectively.
Step 6. Press & keys to move the cursor
downward or upward. The screen is
also scrolled down or up respectively.
The following items can be selected.
W a l k T e s t
T e l . S e t t i n g s
G e n . S e t t i n g s
D e v i c e d + / -
Step 7. After making a selection by moving
the cursor to the desired item,press
OK to confirm the selection. The
display will show you the individual
programming screen accordingly.
<
<
N
N
O
O
T
T
E
E
>
>
If a down-arrow symbol
V
appears on
the last column of the screen, it
indicates the selection list can be
downwards scrolled. If the lowest
position is reached, the down-arrow
symbol disappears.
If an up-arrow symbol
Λ appears on
the last column of the screen, it
indicates the selection list can be
upwards scrolled. If the upper
position is reached, the up-arrow
symbol disappears.
Pressing , the screen will also return
to Alarm Off screen.
After User1, 2, 3 & 4 PIN codes and
Master code are programmed with
new numbers, remember to enter the
newly
programmed
codes
when
accessing
Programming
mode
afterwards.
In Programming mode, if no key is
pressed within 5 minutes, the Control
Panel
will
automatically
exit
Programming mode to Alarm Off
mode.
2.2. Telephone Settings
In Telephone Settings menu, the following
parameters can be programmed at your
discretion.
* T e l . N u m b e r s
R e c . A d d r e s S
T e s t R e p o r t
2.2.1.Telephone Numbers