Garmin GNS 530AW Installation Manual - page 99
500W Series Installation Manual
Page 5-21
190-00357-02
Rev. D
5.3.20 GAD 42 CONFIG Page
The following page is only available if a ARINC 429 input
is configured for the GAD 42.
Select the GAD 42 CONFIG page (see Figure 5-25). This
page allows remote configuration of a GAD 42 Interface
Adapter Unit. For details of this function, please see
Section 5 of the GAD 42 Installation Manual (P/N 190-
00159-00).
5.3.21 TAWS AUDIO CONFIG 1 Page
(Only if TAWS is installed)
Select the TAWS AUDIO CONFIG 1 page (see Figure
Figure 5-26). This page allows configuration of TAWS
audio.
5.3.21.1 VOICE Field
Selection Description
Female
Select the female voice to annunciate TAWS alerts. (Default)
Male
Select the male voice to annunciate TAWS alerts.
5.3.21.2 PLAY MSG Field
The PLAY MSG field allows the playback of all the individual TAWS alert messages. It does not
control the configuration of the messages in any manner.
5.3.21.3 VOLUME Field
The VOLUME field sets the volume of the TAWS alerts from 0% volume (left side) to 100% volume
(right side). The default value is 60% of the maximum value. The TAWS volume needs to be set so as
to ensure that aural alerts are audible under all anticipated noise environmental conditions. Refer to
Section 5.4.7 for the TAWS Audio Check procedure.
5.3.21.4 PDA-CAUTION Field
Selection Description
Too Low - Terrain
Sets the Premature Descent Rate (PDA) cautionary alert to the
specified text. (Default)
Figure 5-25. GAD 42 CONFIG Page
Figure 5-26. TAWS AUDIO
CONFIG 1 Page