JabloCom EYE-02 User Manual - 4.2
JR_EYE‐02.ENG.MAN.MANUAL.10.DOCX
‐ 8 ‐
JABLOTOOL WEB server
JabloTool WEB is a service at
www.jablotool.com
and it is provided for free for registered users.
User accessing the EYE‐02 camera trough the JabloTool WEB will be guided to establish the connection to
camera. If user is not registered or if the EYE‐02 camera is not protected by Remote Access Password, user
has to send a special SMS authorization command from his mobile phone first to initiate the EYE‐02 camera
connection to the JabloTool.
Authorization between the JabloTool WEB server and EYE‐02 camera
JABLOTOOL DESKTOP software
Load the installation CD to your computer, start the "
INSTALL.EXE
" and follow the program instructions.
Do not connect the EYE‐02 camera to the USB on your computer until you have finished installing the JabloTool
software from the CD!
The latest version of the installation software can be download at
www.jabblotool.com/download
.
Turn the camera On and connect it to the computer by the USB cable. Wait until the
operating system recognizes the camera. Then, click on the JabloTool icon on the desktop to
load the program and follow all instruction on the screen.
The maximum length of a USB cable is usually 5 meters. If your EYE‐02 camera is too far, you may need to remove it
temporarily from its location or bring your PC nearer.
4.2
CONFIG
M
ODE
CONFIG mode allows the user to change the camera’s settings, enroll a new external device (e.g. additional
remote controls) to operate with the EYE‐02 camera or enroll a new user’s contact.
To open the CONFIG mode by remote control, press
and
buttons simultaneously – red and green
LED lights in the front panel will start to blink slowly at once.
MODE
DESCRIPTION
COMMAND
ENROLL
In the ENROLL mode, the camera allows to enroll new external wireless devices such
as the remote controls, detectors, sirens, etc. Also a new contact – phone number
can be enrolled in this mode by just a simple call to camera. ENROLL mode is
terminated automatically after one new items has been enrolled.
TEST
TEST mode is a special mode to test all detectors function without causing unwanted
number of alarm reports.
REPORT
In the REPORT mode, the camera sends a special report of “Test of camera
originated by user” to all contacts (as SMS and e‐mail)
press
and
buttons simultaneously
for about 4 sec
USB
This is special mode of camera in which camera activates its USB driver and behaves
as a standard USB flash disk. This allows to access files on SD memory card without
installation of special camera driver to PC.
Press power
button on
camera back
panel