JabloCom EYE-02 User Manual - 4.5
JR_EYE‐02.ENG.MAN.MANUAL.10.DOCX
‐ 11 ‐
4.5
V
IDEO
R
ECORD
S
ETTING
The EYE‐02 camera allows detail setting of all important parameters to collect video record under many
conditions.
Parameter
Settings
Description
Snapshoot rate
from 20 frames per sec, to 1 frame
every 30sec
The frequency of snapshots. The higher frequency
increases the video record file size.
After ALARM keep on
recording video for
(0 sec, 5sec, 10sec ,... 2 min, 5 min,
10 min)
Camera keeps video recording for some time period
after ALARM.
Only save pictures when
motion is detected
Next snapshoot (frame) will be saved to video record file only if there has been detected the
change compare to previous snapshoot. If the pictures are almost the same it will not be stored.
This setting SIGNIFICANTLY reduce the video file size
Image size
160x120, 320x240, 640x480 pixels
Image resolution in pixels. Higher resolution increase
the quality of recorded pictures but it also increase the
size of video files and lengthen the time for transfer it
via GSM network.
Image quality
5 levels of JPEG compression
Level of JPEG compression. Higher compression reduce
the file size and slightly decrease the detail resolution
in picture
Filter fluorescent lamps
(OFF, 50Hz, 60Hz), default OFF
If the scene is illuminate by the standard fluorescent
lamps, this will filter undesirable lamp blinks. Set the
standard AC power frequency in your country
Brightness compensation
+/‐ 2EV, with step 0.5EV, default 0
The camera calculates the best brightness of pictures
automatically. This setting allows changing the pre‐set
level of brightness.
Expected speed of the
objects (Shutter speed)
(fast, normal, slow), default normal
Default setting is NORMAL. Set of FAST in case there
may be some fast moving objects in front of camera
(cars, running persons, etc.), SLOW is suitable mainly
for door control and dark rooms.
Disable build‐in infrared lamp
The internal IR lamp is automatically switched on when the lightness of scene is too low for
normal camera function. This option disables the automatic function and it is mostly used if the
illumination is done by external lamp.
Insert date and time into
picture
The small timestamp will be inserted into the left top corner of picture. This help to determinate
exactly the time of snapshoot.
Capture video when PIR or
MIP activity in SLEEP mode
The video recording continues also in SLEEP mode if there is some activity detected in front of
camera. This is well usable for shops, petrol stations and other place where permanent
watching is required
Send video as separate JPEG
pictures
JPG pictures will be send by e‐mail and MMS instead of AVI video files – use this option in case
your mobile phone or PC do not support AVI video files