JabloCom EYE-02 User Manual - 3.4
JR_EYE‐02.ENG.MAN.MANUAL.10.DOCX
‐ 6 ‐
3.4
R
EPORTS
The EYE‐02 camera can report events to mobile phones (via voice call
, text message
, MMS
) or
to e‐mail addresses. Up to 10 different phone numbers and 10 e‐mail addresses can be saved to the camera
list.
To set the contacts, use the JabloTool software, Contacts menu (see chapter 4).
Each stored contact can have its own report level set. Three levels (High, Middle, and Low) indicate how
many events should be reported to the contact. Low level reported contacts will receive ALARMS only,
Middle and High level contacts will receive additional reports for specific events.
JabloTool also allows a user to block some of the reporting channels (calls
, SMS
, MMS
) by
checking‐off the appropriate check‐box on the contact line.
New contacts may also be added via an SMS command (see chapter 4.4, CONFIG commands) or by calling
the EYE‐02 camera directly from a new phone number while the camera is in the
C O N F I G
C O N F I G
mode. If there
are no phones saved in the contact list (after installing a new EYE‐02 camera or after using the factory reset
function), the camera switches automatically to
C O N F I G
C O N F I G
mode and waits for an incoming call.
CONFIG CONTACT
where
Example:
CONFIG CONTACT +48555789456
CONFIG CONTACT email@hotmail.com
Camera sends e‐mail with reply address
noreply@jablocom.com
. Please check your e‐mail client SPAM filter to accept
emails from this address.
3.5
R
EMOTE
C
ONTROL
The package contains a wireless remote control (RC‐86 type), which can be used to
switch between camera modes – see chapter 3‐1.
Change of the mode via the remote control is signaled both by the LED lights on the
camera front panel, and by an acoustic signal. The significance of the LEDs and acoustic
signals is as follows: