Jacobsen Eclipse 322 Repair Manual - page 227
ELECTRICAL
4222983 Second Edition
4-153
4
Rocker Switches
See Figure 4-132.
Figure 4-132
NOTE
This procedure applies to the following switches:
• Left Reel Enable Switch (1)
• Right Reel Enable Switch (2)
• Center Reel Enable Switch (3)
• Light Switch (4)
• Mow Switch (5)
• Horn Switch (6)
Removal and Installation
See Figure 4-133.
1.
Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2.
Remove instrument panel. (See “Instrument Panel”
on page 4-151.)
Figure 4-133
NOTES
• For installation purposes, note orientation of each
switch.
• Label all wires before disconnecting to ensure correct
installation.
3.
Disconnect the wire connectors (8) on the rocker
switch (7).
4.
Depress tabs (9) on each side of the rocker switch
and remove from the instrument panel.
Installation Notes
• Apply dielectric grease (Jacobsen PN 365422) to
connections.
• Use new cable ties to secure wire connectors and
wire harness.
• Install rocker switches by reversing the order of
removal.
Key Switch
Removal and Installation
See Figure 4-134.
1.
Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2.
Remove instrument panel. (See “Instrument Panel”
on page 4-151.)
Figure 4-134
NOTES
• For installation purposes, note orientation of the key
switch.
• Label all wires before disconnecting to ensure correct
installation.
3.
Remove the key.
4.
Disconnect wire connector (1) from key switch
assembly (2).
1
2
3
4
5
TN2331
6
TN2338
8
9
7
TN2345
1
2
3
4