Karcher K 2.110 M Operating Instructions Manual - page 7
English
7
Caution
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the high-pressure pump.
Î
Connect the high pressure hose to the
high pressure connection of the appli-
ance.
Î
Push the spray lance into the trigger gun
and fasten it by turning it through 90°.
Î
Completely open the water tap.
Î
Insert the mains plug into the socket.
Î
Turn on the appliance “I/ON”.
몇
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the trigger gun and spray lance
firmly.
Î
Unlock the lever on the trigger gun.
Î
Pull on the lever of the trigger gun; the
device will switch on.
Note:
Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
Carrying out the most common cleaning
tasks. The work pressure can be stageless-
ly regulated between "Min" and "Max".
Î
Release the lever on the trigger gun.
Î
Turn the spray lance to the desired po-
sition.
For particularly dirty items or areas.
Not suitable for use with detergents.
We recommend the Kärcher cleaning and
care program that will match the respective
cleaning requirements. Please seek consul-
tation or request information on the subject.
Î
Pull detergent suction hose as far as is
required out of the housing.
Î
Suspend end of detergent suction hose
in a container filled with detergent.
Î
Use spray lance with pressure regula-
tion (Vario Power).
Î
Turn the spray lance to "Mix" position.
Note:
This will mix the detergent with
the water stream.
Î
Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
Î
Spray off loosened dirt with the high-
pressure ray.
Î
Release the lever on the trigger gun.
Î
Lock the lever on the trigger gun.
Î
During longer breaks (more than 5 min-
utes), also turn the appliance off using
the "0/OFF" switch.
Î
Insert the trigger gun in its holder.
Caution
Only separate the high-pressure hose from
the hand spray gun or the appliance while
there is no pressure in the system.
Î
After working with detergent, suspend
detergent suction hose in a container
filled with clear water, switch the appli-
ance on for around 1 minute once the
spray lance has been removed and
rinse until water runs clear.
Î
Release the lever on the trigger gun.
Î
Turn off the appliance "0/OFF".
Î
Turn off tap.
Î
Detach the appliance from the water
supply.
Î
Press the lever on the trigger gun to re-
lease any remaining pressure in the
system.
Î
Lock the lever on the trigger gun.
Î
Pull out the mains plug.
Î
Stow away the mains cable, the high-
pressure hose and accessory at the ap-
pliance.
Î
Insert the trigger gun in its holder.
Start up
Operation
Spray lance with pressure regulation
Spray lance with dirt blaster
Working with detergent
Recommended cleaning method
Interrupting operation
Finish operation