Karcher K 5.86 M Operating Instructions Manual - page 8
8
English
According to the applicable regula-
tions, the appliance must never be
used on the drinking water net
without a system separator. Use a
suitable system separator manufactured by
Kärcher; or, as an alternative, a system
separator as per EN 12729 Type BA.
For connection values, see type plate/tech-
nical data.
Observe regulations of water supplier.
Î
Screw the water filter on the water con-
nection of the device.
Î
Screw the delivered coupling part on
the water filter.
Î
Push the water supply hose onto the
coupling unit, then connect it to the tap.
Note:
Use a fibre-reinforced hose (not in-
cluded) with a standard coupling.
– Minimum diameter, 1/2 inches (13 mm).
– Minimum length 7.5 m
몇
Caution
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the high pressure pump.
When fitted with the appropriate accesso-
ries, this high-pressure cleaner can draw in
surface water, e.g. from water butts or
ponds (max. suction height 0.5 m).
Î
Screw the water filter on the water con-
nection of the device.
Î
As the standard coupling system is not
suitable for use in suction mode, the
Kärcher suction hose with integrated fil-
ter should be used instead (special ac-
cessory, order no. 4.440-238) and
suspended inside the water butt.
Î
Remove air from appliance before oper-
ation.
Switch on the appliance without con-
nection the high pressure hose and run
it until the water discharging from the
high pressure outlet is free of bubbles.
Switch off appliance and reconnect high
pressure hose.
Note
: Fill suction hose with water be-
fore use, this will help ventilate the
pump of air.
몇
Caution
Use the high pressure cleaner only when
you have mounted the water filter.
Î
Unwind the high pressure hose from the
hose reel.
Î
Push the appropriate spray lance on to
the trigger gun and fasten it by turning it
through 90°.
Î
Open tap.
Î
Plug in the main plug.
Î
Set main switch to “I/ON”.
Î
Press safety catch on the trigger gun to
release it and pull lever.
몇
Risk of injury
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the trigger gun and spray lance
firmly.
Carrying out the most common cleaning
tasks. The work pressure can be stageless-
ly regulated between "Min" and "Max".
Î
Release the lever on the trigger gun.
Î
Turn the spray lance to the desired po-
sition.
For strong contaminations.
Water supply
Water supply from mains
Drawing in water from open reservoirs
Start up
High pressure operation
Spray lance with pressure regulation
Spray lance with dirt blaster