LaCie 12big Rack Fibre 8 Quick Install Manual - Installation Preparation
LaCie 12big Rack Fibre and expansion
Rack Installation
Quick Install Guide
page 5
Table 1: Parts List for Rail Kit
Item
Qty
Description
1
8
M5 Spring Washer
2
8
Slide Washer Square Hole
3
2
Chassis Side Slide
4
8
Slide Washer Round Hole
5
10
M3 x 4 Buttonhead Patchlock Screw
6
2
Chassis Latch
7
2
Chassis Latch Screw
8
8
M5 x 12 Phillips Patchlock Screw
9
8
10-32 UNF Phillips Screw
10
2
Rack Bracket Assembly
Installation Preparation
3.3.
Remove the plug-in modules (Power Supplies, Cooling Fan
module, RAID Controller or Disk I/O modules, and Disks).
Remove the power supply modules by pushing the latch
above the handle to the right and pulling the module from
the enclosure.
Remove the cooling fan module by grasping the latch be-
tween your thumb and forefinger, squeeze to release the latch
and pull outward to eject the module. Withdraw the module
from the enclosure.
Remove the RAID Controller or Disk I/O modules, using
two hands squeeze your thumbs and forefingers together to
release the latches. Pull out on the latches to eject the module
and withdraw the module from the enclosure.
Tools Required
3.2.
Tools:
Slotted screwdriver.
✦
#2 PoziDisk screwdriver.
✦
#2 PoziDisk screwdriver, stubby.
✦
2 mm Allen key.
✦
iMPoRTanT noTe:
Use of other mounting hardware may
cause loss of rack space, and a danger of failure or injury.
Remove the disks. Disk carrier modules are shipped from
the factory with the anti-tamper locks enabled. Using the
key provided in the accessory kit, insert the key into the
cutout in the handle and rotate in a counter-clockwise
direction until the “red” indicator is not visible. Release
the carrier handle by pressing the latch in the handle with
your forefinger and rotating the handle to the right to eject
the carrier. Using the handle gently withdraw the carrier
module from the enclosure.
Rack Installation Procedures
3.4.
Place the empty enclosure chassis on a stable work
1.
surface. Remove the Rack Mounting Rail kit from the
accessory kit, inspect the contents and check for damage.
Attach the left and right chassis slides to the enclosure
2.
sides using six M3x4 button head screws. Three screws
each side see Figure 2 for locations.
Assemble the left and right chassis latches using the
3.
chassis latch screws. Ensure that the latch is orientated
as shown in Figure 2, with the spring arm (small arm
portion) located against its stop. On the right hand side
the stop is located at the top, and on the left side it is
located at the bottom.
Figure 2: Securing Chassis Slides