Lagoon 380 User Manual - page 21
NAVIGATION
19
NAVIGATION
1
LAGOON 380
z
WINDLASS ANCHORING
- Release the anchor clutch.
- Activate the windlass with the control located in the saloon.
z
RAISING THE ANCHOR
- Tighten the gypsy brake.
- Ensure the chain is properly set on the chain gypsy.
- Slowly advance the vessel using your engine (do not use your
windlass to advance the boat).
- Release the bridle from the chain.
- Lift the anchor completely.
- Visually check the last few meters until the anchor makes contact
with the davit.
- Check the position of the anchor on the stemhead fitting.
- Fasten the anchor clutch.
In the case of electrical failure use the winch handle on the windlass
to lift anchor.
z
MAINTENANCE
After each trip rinse the windlass and dockside line with fresh water.
Refer to the manufacturer's instructions for windlass maintenance at
the beginning or end of the season.
WARNING
Windlass operations are dangerous:
- Always keep the anchor line clear and
unencumbered.
- Always proceed with care, using gloves and always
wearing shoes.
WARNING
All anchoring manoeuvres using the electric
windlass must be carried out with the port engine
running.