Lagoon 380 User Manual - page 35
z
AFTER MAST STEPPING
- Lubricate all the turnbuckles (see recommendations in the RIGGING
chapter).
- Tension the rigging (refer to RIGGING chapter for settings).
- Reconnect the electrical cables in the mast step junction box located
in the forward locker of the saloon bench seat.
- Check very carefully that the turnbuckle fixing pins are well locked
and protect them with adhesive tape.
- Re-install the boom and re-lead all the lines.
z
DISMASTING
Proceed by carrying out the operations described for mast stepping in
reverse order, taking care to mark the line locations with labels.
LAUNCHING
33
LAUNCHING
3
LAGOON 380
RECOMMENDATION
Re-adjust the mast after a few miles.
RECOMMENDATION
Before all dismasting operation, remember to
disconnect the electric cables.
Pull gently while guiding the cables.