Lagoon 380 User Manual - page 63
Water tanks
z
FILLING
In order to prevent any handling mistakes, never fill the water and fuel
tanks at the same time.
During filling, avoid handling contaminants near the fillers.
Open and close the filler caps with the suitable key. Check the filler
cap seals for condition during filling. The tanks are fitted with overflow
outlets and vents. Never insert the water filling hose deep down into
the system in order to prevent any over-pressure in the systems.
z
MAINTENANCE
Inspection points are provided on tanks and from which it is possible
to clean the inside.
NB: The capacity of the fresh water tank or tanks indicated on the
'Specifications' may not be completely useable depending on the trim
and load of the boat.
Fresh water filter
The water pump is switched on at the electrical panel.
The 3-way valve enables the water system source to be switched
from the starboard tank to the port tank (optional).
For optimisation of use of fresh water completely use up one tank's
supply before switching over to the other.
z
FRESHWATER SHORE SUPPLY (OPTIONAL EXTRA)
The vessel may be equipped with a connector for the shore supply of
freshwater.
The nozzle on the port transom extension enables a hose to be
connected to supply the onboard system from a quayside freshwater
hydrant.
After having connected the hose turn the 3-way valve located under
the sink to shore.
PLUMBING
61
PLUMBING
7
LAGOON 380
RECOMMENDATION
- Check the quality of the filling water. Make sure
that the water is drinkable.
- The tanks can be sterilized using a Clonazione
tablet (available from chemists).
- In the case of long periods of inactivity purify the
tanks and piping using an appropriate treatment.
RECOMMENDATION
- Never operate the water system equipment when
the valve is closed or the tank is empty (the
electrical equipment may be damaged).
- Check the water filter for condition (refer to
manufacturer's instructions).