Lanier 5555 Operator's Manual - page 148
When Placing Original on Exposure Glass
6 - 16
Using the Finisher
7
Place the original on the Exposure Glass and press the START key.
•
Place the original face-down on the Exposure Glass with the bot-
tom toward you and the left side centered against the original
scale.
•
Place the first page of the originals first. When SADDLE
STITCH is selected, refer to the illustration to set the pages in
order.
•
When the first original was placed vertically, the second-side
original should be placed in the same direction.
•
When the first-side original was placed horizontally, the second-
side original should be placed horizontally, but in the opposite
direction.
8
When the first original has finished being scanned, touch the YES key. Set the next original and press the START
key.
•
You can start scanning by pressing the START key. It is not necessary to touch the YES key.
9
For additional originals, repeat step 8.
10
When the last original is scanned, touch the FINISHED key.
11
Copies exit onto the paper bins of the Finisher. When the Finisher Bins reach their maximum capacity, the
following message appears:
Finisher full: Remove paper
•
Remove the copies from the paper bins and press the START key to continue.