Lanier 5555 Operator's Manual - Copier Terms
Copier Terms
Glossary
G - 4
specifics on your Copier, check the Specifications section of this Guide.
Exit Tray
A tray attached to the output end of the copier to collect copies. This tray is usually removed when a Sorter or Finisher is installed.
In this case, the top tray of the Sorter or Finisher serves as the Exit Tray.
The glass surface located under the Document Cover or Document Feeder. The original is placed here to make a copy. If an RADF
is present, it transports the original to this location. Once here, the original is exposed by the Exposure Lamp located directly
below the glass.
Exposure Lamp
The light source located directly below the Exposure Glass. It is the light from this lamp that exposes the original, reflects off the
original, travels through the optics and exposes the Drum.
Exposure Pad
A Pad located on the bottom side of a Document Cover used to hold an original in place on the Exposure Glass during the
exposure process.
Factory Default
A setting in the copier that is set at the factory. You can change some of these settings. Others can be changed by a Service
Technician. See also Initial Setting.
Front Cover
The Cover located at the front of the copier designed to allow access to the interior of the copier. This allows the operator to add
supplies, remove paper misfeeds, or perform other maintenance as prescribed by the Operator Guide.
Fused Toner
The image, usually black, that adheres to the surface of the copy paper. This Toner is “Fused” to the surface of the paper using
pressure and heat.
Fuser Assembly
The unit located inside the exit area of the copier that provides heat and pressure to attach the toner to the paper surface.