Lanier 5555 Operator's Manual - page 97
Trimming and Masking Copies
Copying Methods
4 - 45
3
Touch the TRIM or MASK key, depending on which operation you
want to perform.
Note:
If the Access Code function is being used, you must enter an
Access Code before you can enter the X and Y values.
4
Enter the X1 value using the keypad and then touch the SET key
located at the right.
•
This advances the cursor to the X2 value.
5
If you make an error entering the value, press the RESET key.
6
Enter the X2 value using the keypad and then touch the SET key
located at the right.
•
This advances the cursor to the Y1 value.
7
Enter the Y1 value using the keypad and then touch the SET key
located at the right.
•
This advances the cursor to the Y2 value.
8
Enter the Y2 value using the keypad.
9
If all your values are correct, touch the SET key at the bottom of the Touch Screen. This enters these values into the
copier’s memory.