Lanier R/C MARINER 40 MK II ARF Assembly Instructions Manual - Canopy
Assembly Instructions
Canopy
Lanier R/C, INC. P.O. Box 458 Oakwood, Ga. 30566 PH 770 532 6401
© copyright 1989 Lanier R/C
10
10
Bolt the wing in place on the fuselage
using the 4mm bolts and flat washers, the
blind nuts are already installed. Fit the
wing cover in place with the dowel in the
hole in the F2 bulkhead. Use a pencil and
make a mark on the wing approximately 2-
1/2” in front of the leading edge at the
edge of the wing cover.
Remove the wing cover and measure over
from the line you drew 3/16”. This should
be at the outside edge of the wing bolt
reinforcement plate at the trailing edge of
the wing. Take the two 3/8” x 1-3/8” x
7/8” wooden blocks and place on this line
at the front of the wing bolt reinforcement
plate.
Mark around block on both sides and
remover the covering on the wing under the
marks. Epoxy the blocks in place.
Make a mark on the wing at the center of
the block. Reinstall the wing cover and
measure up 1/2” from the surface of the
wing on the wing cover at the mark you
made. Drill a 9/64” hole through the wing
cover and into the block. Repeat for the
other side. Remove the wing cover and
enlarge the hole in the block to accept the
4mm blind nut (7/32”). Seat the blind nut
by installing the screw in the block without
the wing cover in place and screwing the
bolt into the blind nut pulling it into the
wood. Very carefully glue the blind nut in
place on the back side making sure not to
get glue into the threads. Remove the bolts
and reinstall the wing cover with the bolts
in place.